Step 1: Power off the machine first.
Step 2: Remove the rubber strip from the gap on the right side of the lid. Take out the wire from the gap and move it to the left.
Step 3: Take out the rubber seal on both sides of the bottom left and right corners, close the lid, and remove the entire piece of the rubber seal.
Step 4: Keep the lid closed, insert the rubber strip into the gap of the machine frame,
- pay attention to the position of the rubber strip, and ensure that the protruding part is facing upwards.
Step 5: Keep the lid half open, about 30 degrees. Adjust the position of the rubber seal.
Step 6: Open the lid, take a tool, for example, a steel ruler, and slowly insert the rubber strip into the corresponding position.
Step 7: Install the wire and the white rubber strip mentioned in Step 2 to the its original gap.
Step 8: Close the lid and adjust the postion of the rubber seal again to achieve the final effect as shown below.
For video tutorials, please click on the link:
how to remove the rubber seal?
how to install the rubber seal?