When using WeCreat laser engraving/cutting machine, it can produce visible or invisible smoke and odors during processing. The chemical composition of these smoke and odors depends on the material being processed, and may be unpleasant or have an bad smell, or even be harmful to human or pet's health.
Please operate the WeCreat laser machine only when the exhaust hose is connected to the outdoor or the WeCreat fume extractor. If ventilation is poor, smoke and odors may escape into the room and pose a health hazard.
If venting to the outdoor, ensure that it will not cause inconvenience to neighbors or passersby, and remember to check if local air quality regulations apply to you.
Do not open the machine's top lid before the fan stops rotating to prevent smoke and odors from escaping from the equipment.
Carefully follow all the operating instructions in the user manual.
There may be some odors during operation. However, if you smell strong, pungent odors and feel eye, nose, or throat irritation, or there is obvious smoke escaping when the cover is closed, immediately stop and recheck the exhaust system. If the irritation and/or smoke emissions do not decrease, stop using WeCreat and contact WeCreat technical support at support@wecreat.com .
If you directly connect the exhaust hose to the outdoor, please pay attention to waterproofing and dust-proofing at the end of the hose; when not using the machine, we recommend placing the end of the exhaust hose indoors to avoid outdoor rain/humidity/dust from entering the product and causing damage.