If the long board you are using are uneven, curved, or have two warped corners, it is very likely that the board will touch the machine frame when feeding and will not pass through the machine.
Please follow the instructions below for normal use.
Note: this method can only be used on boards with a thickness of more than 3 mm.
- Use the boards that come with the machine or other 3mm thick boards. Cut two strips with 400mm long and 45mm wide.
- Place two wood strips into the grooves on the left and right frames of the Pass-through Feeder.
- Adjust the machine position, ensuring that the bases at the four corners of the bottom of the machine are correctly placed on the wood strips.